Before Start Of Operation - Makita EM4350RH Original Instruction Manual

BEFORE START OF OPERATION

Inspection and refill of engine oil
Perform the following procedure, with the engine cooled down.
●
Assure that the engine is on a flat horizontal surface and confirm if the oil level
●
is between the lower (1) and upper (2) limit of the oil indicator.
If the oil level is below the lower limit, remove the oil cap and add oil.
●
The area surrounding the external marks is transparent, so the amount of oil
●
inside can be checked without having to remove the oil cap. However, if oil
pipe becomes extremely dirty, visibility may be lost, and oil level will have to be
checked against stepped section on inside of oil pipe.
You may need to refill oil approximately every 10 operating hours (every 10
●
refuellings).
If the oil changes in color or mixes with dirt, replace it with new one. (For the
interval and method of replacement, refer to P 23.)
Recommended oil: SAE 10W-30 oil of API Classification, Class SF or higher (4-stroke engine for automobile)
Oil volume: Approx. 0.10L
NOTE:
If the engine is not positioned as illustrated on a horizontal surface, an inaccurate indication of oil level may occur and oil may be overfilled.
●
Filling oil above the upper limit may cause oil contamination and/or white smoke.
Replacement of oil: "Oil cap"
Remove dust or dirt near the oil refill port, and detach the oil cap.
●
Keep the detached oil cap free of sand or dust. Otherwise, any sand or dust adhering to the oil cap may cause irregular oil circulation or wear
●
on the engine parts, which will result in troubles.
(1) Keep the engine level, and detach the oil cap.
(2) Fill with oil to upper limit mark.
Use oil bottle when filling.
(3) Securely tighten the oil cap. Insufficient tightening may cause oil leakage.
14
(2)
(1)