Introduction & Quick Start Instructions - Check-line DCF-900 User Manual

1.0. Introduction & Quick Start Instructions
The DCF-900 and DCN-900 Coating Thickness Gauges represent the
latest technology for the non-destructive measurement of coatings and
plating. While both gauges are very easy and convenient to use, the
first-time user should read this entire manual before operating the
gauge for the first time to minimize operating problems and to fully
utilize the instrument's capabilities. A glance through the Table of
Contents will outline the areas covered by this manual and will give
the user a quick indication of where answers may be found to questions
that may arise in the future.
QUICK START OPERATING INSTRUCTIONS
1. Press ON key. LCD display shows
ru.n or run.
2. Place probe tip in contact with part being
checked, pressing down slightly until the
V-notched shell is flush with the surface.
A reading in mils XX.X or microns XXX
will appear.
3. Note reading and lift probe.
4. For additional tests, repeat steps 2 & 3.
GAUGE AUTOMATICALLY POWERS OFF
AFTER 90 SECONDS OF NON-USE
NOTE:
This gauge normally doesn't require calibration
before use. To verify or change calibration – or change
units (mils vs. microns) – See User's Guide
ELECTROMATIC Equipment Co., Inc.
Cedarhurst, NY 11516 – USA
TEL 516-295-4300
•
FAX 516-295-4399
–2 –
11.0 Limited Warranty
ELECTROMATIC Equipment Co., Inc. (ELECTROMATIC) warrants to the original
purchaser that this product is of merchantable quality and confirms in kind and quality
with the descriptions and specifications thereof. Product failure or malfunction arising
out of any defect in workmanship or material in the product existing at the time of
delivery thereof which manifests itself within one year from the sale of such product,
shall be remedied by repair or replacement of such product, at ELECTROMATIC's
option, except where unauthorized repair, disassembly, tampering, abuse or misapplica-
tion has taken place, as determined by ELECTROMATIC. All returns for warranty or
non-warranty repairs and/or replacement must be authorized by ELECTROMATIC, in
advance, with all repacking and shipping expenses to the address below to be borne by
the purchaser.
THE FOREGOING WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO, THE
WARRANTY OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR
PURPOSE OR APPLICATION. ELECTROMATIC SHALL NOT BE RESPONSIBLE
NOR LIABLE FOR ANY CONSEQUENTIAL DAMAGE, OF ANY KIND OR
NATURE, RESULTING FROM THE USE OF SUPPLIED EQUIPMENT, WHETHER
SUCH DAMAGE OCCURS OR IS DISCOVERED BEFORE, UPON OR AFTER
REPLACEMENT OR REPAIR, AND WHETHER OR NOT SUCH DAMAGE IS
CAUSED BY MANUFACTURER'S OR SUPPLIER'S NEGLIGENCE WITHIN ONE
YEAR FROM INVOICE DATE.
Some State jurisdictions or States do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation may not apply to you. The duration
of any implied warranty, including, without limitation, fitness for any particular purpose
and merchantability with respect to this product, is limited to the duration of the
foregoing warranty. Some states do not allow limitations on how long an implied
warranty lasts but, not withstanding, this warranty, in the absence of such limitations,
shall extend for one year from the date of invoice.
ELECTROMATIC Equipment Co., Inc.
600 Oakland Ave. Cedarhurst, NY 11516—USA
Tel: 1-800-645-4330/ Tel: 516-295-4300/ Fax: 516-295-4399
Every precaution has been taken in the preparation of this manual. Electromatic Equipment Co., Inc.,
assumes no responsibility for errors or omissions. Neither is any liability assumed for damages
resulting from the use of information contained herein. Any brand or product names mentioned here-
in are used for identification purposes only, and are trademarks or registered trademarks of their
respective holders
– 15 –