Chapter 4: Calibration; Calibration Mode - acaia Cinco Operation Manual

Note
1. In Auto Start Mode, the timer will stop when the espresso flow stops
2. The auto-tare function is performed when the weight exceeds 2 grams.
3. If you do not operate the scale for 14 seconds, it will reset the timer and perform tare operation.
4. In Auto Start Modes, the timer will also stop when a negative weight (i.e. removal of cup) is
detected.
*To Enable/Disable Auto Start Mode, please go to Chapter 5: Configuration.

Chapter 4: Calibration

Calibration Mode

1.
While the scale is in Weighing Mode and the weighing unit is in gram, press
until LED display shows [ CAL ] and then [ 100 ].
2. Place a 100g calibration weight on scale and wait for the scale to execute calibration procedure.
3. The LED display shows [
the calibration weight when completed.
* Note: Calibration weight of 50g,100g, 200g, or 500g can also be used.
Chapter 3: Basics
_End_
] when the calibration procedure is completed. You may unload
T
Button rapidly
13