Product Care Information; Battery Charge; Calibration - acaia Pearl User Manual

Product Care Information

Battery charge

• You can charge the battery by plugging the USB cable into
any of the power supplies listed below:
• A computer
• A USB wall-charger with an output of 5 volts and 1 amp
• A DC car-charger with an output of 5 volts and 1 amp
• It takes about 1-2 hours to fully charge the battery from
empty. Try not to let the battery completely run out before
charging. Charge the battery as needed, but it is best not to
exceed more than once a week.
• A fully charged battery can work continuously for about 25
hours.
• Battery percentage can be viewed via the Acaia apps.
* Note: Using a "fast-charging" charging block or charging hub (a charging block/hub delivering
over 5v at 1A) could damage your Acaia scale's circuit board.

Calibration

Turn on scale
Turn on the Acaia
scale.
Tap T button
Make sure the scale
is in weighing mode
and the unit is set to
'gram', then tap the
'T' button rapidly.
See CAL display
Keep tapping the 'T'
button until 'CAL' is
shown on the
display.
Place a weight
Place a weight
(100g/500g/1000g)
on the scale and
wait until the
display shows
'_End_'. Calibration
is now complete!
5