Table of Contents
Advertisement
Product Care Information
Battery Charge
• You can charge the battery by plugging the USB cable into
any of the power supplies listed below:
• A computer
• A USB wall-charger with an output of 5 volts and 1 amp
• A DC car-charger with an output of 5 volts and 1 amp
• It takes about 1-2 hours to fully charge the battery. Try not to
let the battery completely run out before charging. Charge
as needed.
• Remaining battery power percentage can be viewed via the
Acaia apps.
* Note: Using a non-certified charger could damage your Acaia scale's circuit board or battery.
Calibration
Turn on scale
Turn on the
Acaia Pyxis.
Care and Cleaning
• Use a soft cloth with warm water only to clean the product.
• Do not use detergent or other chemicals for cleaning and soaking as it can damage the
anodized coating on the product.
Tap T button
Make sure the scale
is in the weighing
mode and the unit
is set to 'gram', then
tap 'T' button rapidly.
Scale displays "CAL"
Keep tapping 'T'
button until 'CAL' is
shown on the
display.
Place a weight
Place a 100 g weight
on the scale and wait
until the display shows
'_End_'.
Calibration is now
complete.
5
Advertisement
Table of Contents
