Rs-232 Controller Connection; Connecting 12-Volt Trigger Outputs To External Equipment; Rs-232 Control System Connection; Connecting 12-Volt Trigger Outputs - Runco High Definition Owner's Operating Manual

Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 Control port on the DHD Controller; see Figure 3-11.
For more information about using this connection, refer to Serial Communications on
page 55.
TRIGGERS
1 2
Pb Pr Y S-Video 1
Component Video Video S-Video 2 RS-232 Out
to Automation/
Control System
or PC
Figure 3-11. RS-232 Control System Connection
If your home theater contains equipment that responds to 12-Volt triggers, connect it to
the 12-Volt trigger outputs as shown in Figure 3-12.
to 12-Volt
trigger-activated
equipment
Figure 3-12. Connecting 12-Volt Trigger Outputs
PlasmaWall XP Series Owner's Operating Manual
IR
3
RS-232 Control
TRIGGERS
1 2
Pb Pr Y S-Video 1
Component Video Video S-Video 2 RS-232 Out
Sleeve = Ground
Tip = +12V
5 4 3 2 1
6
9 8 7
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
IR
3
RS-232 Control
3.5-mm
mini plug
29
Installation
RS-232 Controller
Connection
Connecting 12-Volt
Trigger Outputs to
External Equipment