Cable Management - Runco High Definition Owner's Operating Manual

Installation

Cable Management

➤
To reduce cable clutter, use the cable clamps provided with the PlasmaWall to bundle the
video, audio and control cables at the back of the display. Install the clamps as shown in
Figure 3-15.
Securing the AC cord to the rear of the panel (XP-50DHD)
1. Open the clamp.
Clamp
Note: The power plug provided with your panel may differ from the one shown here.
Securing the AC cord to the rear of the panel (XP-65DHD)
3
2
Note: The power plug provided with your panel may differ from
the one shown here.
Securing the AC cord to the rear of the panel (XP-103DHD)
Plug the AC cord into the power inlet on the
panel until it clicks.
Attach the clamp.
Note: Make sure that the AC cord is locked.
Using Cable Ties
Pass the cable fixing
band through the clip
as shown.
1
Figure 3-15. Cable Management
2. Insert the AC cord 3. Slide the clamp upward
and close the clamp
securely.
AC cord
Connect the AC cord plug to
1
the panel.
2 Attach the left clamp.
1
3 Attach the right clamp.
To close:
To open:
To secure cables connected to the panel, wrap the cable tie around them.
Then, pass the pointed end through the locking block as shown. Ensure that there is
sufficient slack in the cables to minimize stress, especially in the power cord.
To tighten:
Pull
2
32
4. Insert the end of the
to secure the AC cord.
To loosen
the clamp:
To close:
To open:
Push until the
hook clicks.
Squeeze the
tabs together
and pull out.
To loosen:
Push the catch
PlasmaWall XP Series Owner's Operating Manual
clamp band into the
small hole on the lower
right of
the back
cover.
Push until the hook clicks.
Squeeze the tabs together
and pull out.
Unplug the AC cord
Press the two tabs together
and pull out.
Pull