Rs-232 Connection From The Dhd Controller To The Plasmawall - Runco High Definition Owner's Operating Manual

Installation
Digital Video Connection: The PlasmaWall has a dual HDMI input board, labeled HDMI
(SLOT 2). Connect the HDMI output from the DHD Controller to input "A" on this board,
using an HDMI-to-HDMI cable.
Some PlasmaWall XP Series models have a DVI input board (labeled DVI-D IN (SLOT 2))
in place of the dual HDMI input board. Connect the HDMI output from the DHD Controller
to this input, using a DVI-to-HDMI cable or equivalent cable/adapter combination.
RS-232 Connection: Connect the RS-232 output from the DHD Controller to the
SERIAL input on the PlasmaWall. Use a standard, modular telephone cable with RJ11
plugs at both ends. On the PlasmaWall end, use the provided RJ11-to-DB9 adapter. This
adapter is wired as shown in Figure 3-6.
XMT DATA
4
RCV DATA
3
SIG GND
2, 5
To/From
DHD
Controller
1, 6
RJ-11 Male
Figure 3-6. RS-232 Connection from the DHD Controller to the PlasmaWall
RCV DATA
XMT DATA
SIG GND
REQUEST TO SEND
CLEAR TO SEND
NO CONNECTION
24 PlasmaWall XP Series Owner's Operating Manual
3
PlasmaWall
1 5
2
5
6 9
8
SERIAL
7
1, 9
DB-9 Female