Quick Setup - Runco High Definition Owner's Operating Manual

Table 3-1 gives a quick overview of the PlasmaWall installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
1 Mount the PlasmaWall on a wall, table stand or floor ped-
estal
2 Connect the DHD Controller to the PlasmaWall
3 Connect signal sources to the DHD Controller
4 Connect external controller to DHD Controller RS-232 port
(optional)
5 Apply power to the PlasmaWall
6 If using the PlasmaWall with a computer, adjust computer
display properties
7 Display calibration: adjust the following for analog inputs;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance
8 Repeat Step 7 for digital inputs
PlasmaWall XP Series Owner's Operating Manual
Procedure
For Details, refer to
page...
18
22
25
29
33
33
37
48
17
Installation
3.2

Quick Setup