Makita UR100D Instruction Manual page 15

1
2
1. Front grip 2. Shaft
1. Hole
Replacing the nylon cord
WARNING:
metal wire, rope or the like. Use recommended nylon cord only, otherwise it may cause damage to the tool and
WARNING:
Make sure that the cover of the nylon cutting head is secured to the housing properly as
described below.
Replacing the plastic blade
If the plastic blade is worn out, replace it with a new
one. To install the plastic blade, align the direction of the
blade with the mark on the plastic blade head, and then
insert it all the way until it locks in place with a little click.
To remove the plastic blade, perform the installation
procedure in reverse.
1
1. Blade 2. Mark
NOTE: If the plastic blade is worn out, the vibration
increases when the machine is operated with no-load.
1
15 ENGLISH
2