Makita UR100D Instruction Manual page 11

Installing the protector
CAUTION:
While installing the protector, be
careful not to contact the nylon cord cutter on
the protector. Contact with the cutter could result in
2
1. Screw 2. Protector
and then secure it with two screws.
Installing nylon cutting head
Optional accessory
CAUTION:
If the nylon cutting head accidentally
impacts a rock or hard object during operation, stop
the tool and inspect for any damage. If the nylon cut-
ting head is damaged, replace it immediately. Use of a
CAUTION:
after installation.
CAUTION:
When installing or removing the
nylon cutting head, be careful not to contact the
nylon cord cutter on the protector. Contact with the
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
1. Turn the tool upside down so that you can replace
the cutting tool easily.
2. Insert the hex wrench through the hole on the motor
housing and rotate the spindle until the spindle is locked.
1. Hex wrench 2. Hole 3. Spindle
1
1 2
3. Place the nylon cutting head onto the spindle and
tighten it by turning it clockwise.
1. Nylon cutting head
Remove the hex wrench.
To remove the nylon cutting head, turn it counterclock-
wise while locking the spindle with the hex wrench.
Installing plastic blade head
Optional accessory
CAUTION:
impacts a rock or hard object during operation, stop
the tool and inspect for any damage. If the plastic
blade is damaged, replace it immediately. Use of a
CAUTION:
after installation.
CAUTION:
plastic blade head, be careful not to contact the
nylon cord cutter on the protector. Contact with the
CAUTION:
out, replace it with a new one. If it is worn out, the
plastic blade may be thrown away from the plastic
NOTICE:
Be sure to use genuine Makita plastic
blade.
1. Turn the tool upside down so that you can replace
the cutting tool easily.
2. Insert the hex wrench through the hole on the motor
housing and rotate the spindle until the spindle is locked.
3
1. Hex wrench 2. Hole 3. Spindle
11 ENGLISH
If the plastic blade accidentally
When installing or removing the
If the plastic blade head is worn
2
1
1
3