Makita UR100D Instruction Manual page 10

Installing the front grip
Attach the front grip to the front grip holder and secure
it with a hex bolt and the thumb nut as shown in the
1
2
1. Front grip 2. Thumb nut 3. Hex bolt
grip angle, loosen the thumb nut, set the front grip at an
proper angle according to your work and then tighten
Installing the wire guard
NOTICE:
too much. Otherwise it may break.
cutting head, attach the wire guard to the protector so
that it controls the cutting range.
Slightly expand the wire guard outward and then insert
it into the holes of the protector.
For nylon cutting head:
Attach the wire guard to the holes on the front side of
the protector. The nylon cord mark on the protector
indicates the hole to be used.
3
1. Hole
For plastic blade head:
Attach the wire guard to the holes on the rear side of the
protector. The blade mark on the protector indicates the
hole to be used.
1. Hole
When wire guard is not in use, lift it for the idle position.
1. Wire guard
10 ENGLISH
1
1
1