Usb Board And Security Bracket - HP 15-cx0000 Maintenance And Service Manual

USB board and security bracket

Description
USB board for use only in models with GeForce GTX 1060 Max-Q graphics
USB board for use all models without GeForce GTX 1060 Max-Q graphics
USB board cable
Security bracket
Before removing the USB board and security bracket, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
To remove the USB board and security bracket:
1. Disconnect the larger (system board) (1) and smaller (power button board) (2) cables from the USB
board ZIF connectors.
2. Remove the two Phillips M2.0×5.0 screws (3) that secure the security bracket to the computer.
3. Lift the bracket from on top of the board (4).
4. Remove the two Phillips M2.0×3.0 screws (5) that secure the USB board to the computer.
Bottom cover on page
Battery on page 39).
Hard drive on page 47).
36).
Component replacement procedures
Spare part number
L20336-001
L20337-001
L20351-001
L20353-001
55