Solid-State Drive (Ssd) - HP 15-cx0000 Maintenance And Service Manual

Solid-state drive (SSD)

IMPORTANT:
module. You cannot simultaneously install both an Optane memory module and a solid-state drive in the
computer.
Description
256 GB, PCIe
128 GB, PCIe
128 GB, SATA-3
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the solid-state drive:
▲ Remove the Phillips M2.0×3.0 screw (1), and then pull the drive from the socket (2).
Reverse this procedure to reassemble and install the solid-state drive.
The M.2 connector that supports a solid-state drive can also support an Optane memory
Bottom cover on page
Battery on page
36).
39).
Component replacement procedures
Spare part number
L21752-001
L21751-001
L21750-001
45