Operation - Makita DGA408 Instruction Manual

model
1
2
3
1. Sanding lock nut 2.
1. Mount the rubber pad onto the spindle.
2. Fit the disc on the rubber pad and screw the sand-
ing lock nut onto the spindle.
3.
tighten the sanding lock nut clockwise with the lock nut
wrench.
reverse.

OPERATION

WARNING:
It should never be necessary to
force the tool.
could cause dangerous wheel breakage.
WARNING:
ALWAYS replace wheel if tool is
dropped while grinding.
WARNING:
NEVER bang or hit grinding disc
or wheel onto work.
WARNING:
Avoid bouncing and snagging
the wheel, especially when working corners,
sharp edges etc.
kickback.
WARNING:
NEVER use tool with wood cutting
blades and other saw blades. Such blades when
CAUTION:
Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION:
Always wear safety goggles or a
face shield during operation.
CAUTION:
After operation, always switch off
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
CAUTION:
one hand on housing and the other on the side
handle.
Grinding and sanding operation
3. Rubber pad
workpiece.
In general, keep the edge of the wheel or disc at an
angle of about 15° to the workpiece surface.
During the break-in period with a new wheel, do not
the workpiece. Once the edge of the wheel has been
forward and backward direction.
Operation with abrasive cut-off /
diamond wheel
Optional accessory
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
-
grinding.
excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel
of kickback, wheel breakage and overheating of the
in the workpiece. Let the wheel reach full speed
and carefully enter into the cut moving the tool
forward over the workpiece surface.
started in the workpiece.
change the angle of the wheel.
the wheel to crack and break, causing serious per-
ated perpendicular to the material being cut.
12 ENGLISH
WARNING:
When using an abrasive cut-off
WARNING:
NEVER use cut-off wheel for side
WARNING:
Do not "jam" the wheel or apply
WARNING:
Do not start the cutting operation
WARNING:
During cutting operations, never
WARNING:
A diamond wheel shall be oper-
-