Operation - Makita GA7082 Instruction Manual

Dust collecting wheel guard for cut-off (for model
GA9080 / GA9081 / GA9082)
Fig.25
NOTE: For information how to install the dust collect-
ing cover, refer to the manual of the dust collecting
cover.
Connecting a vacuum cleaner
Optional accessory
WARNING:
Never vacuum metal particles
generated by operation. Metal particles generated
by such operation are so hot that they ignite dust and
the filter inside the vacuum cleaner.
To avoid dusty environment caused by masonry cut-
ting, use a dust collecting wheel guard and a vacuum
cleaner.
Refer to the instruction manual attached to the dust
collecting wheel guard for assembling and using it.
2
Fig.26
► 1. Dust collecting wheel guard for cut-off 2. Hose of
the vacuum cleaner

OPERATION

WARNING:
force the tool. The weight of the tool applies ade-
quate pressure. Forcing and excessive pressure
could cause dangerous wheel breakage.
WARNING:
dropped while grinding.
WARNING:
wheel.
WARNING:
the wheel, especially when working corners,
sharp edges etc. This can cause loss of control and
kickback.
WARNING:
blades and other saw blades. Such blades when
used on a grinder frequently kick and cause loss of
control leading to personal injury.
WARNING:
wheel may result in wheel explosion and serious
personal injury.
CAUTION:
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION:
face shield during operation.
CAUTION:
the tool and wait until the wheel has come to a
complete stop before putting the tool down.
CAUTION:
one hand on housing and the other on the side
grip (handle).
Grinding and sanding operation
1
Fig.27
Turn the tool on and then apply the wheel or disc to the
workpiece.
In general, keep the edge of the wheel or disc at an
angle of about 15° to the workpiece surface.
During the break-in period with a new wheel, do not
work the grinder in forward direction or it may cut into
the workpiece. Once the edge of the wheel has been
rounded off by use, the wheel may be worked in both
forward and backward direction.
13 ENGLISH
It should never be necessary to
ALWAYS replace wheel if tool is
NEVER hit the workpiece with the
Avoid bouncing and snagging
NEVER use tool with wood cutting
Continued use of a worn-out
Never switch on the tool when it
Always wear safety goggles or a
After operation, always switch off
ALWAYS hold the tool firmly with
15°