Maintenance - Makita DGA408 Instruction Manual

1. Wire cup brush
brush onto spindle and tighten with supplied wrench.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
brush.
Operation with wire wheel brush
Optional accessory
CAUTION:
Check operation of wire wheel
brush by running tool with no load, insuring that
no one is in front of or in line with the wire wheel
brush.
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance.
damaged wire wheel brush could increase potential
CAUTION:
ALWAYS use guard with wire
inside guard. Wheel can shatter during use and
1. Wire wheel brush
brush onto spindle and tighten with the wrenches.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when
using wire wheel brush.
breakage.
1

MAINTENANCE

CAUTION:
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Air vent cleaning
vents start to become obstructed.
1.
Remove the dust cover from inhalation vent and clean it
for smooth air circulation.
1
1. Dust cover
NOTE: Clean out the dust cover when it is clogged
with dust or foreign matters. Continuing operation
14 ENGLISH
Always be sure that the tool is
1
2
2. Inhalation vent
1