Table of Contents
Advertisement
Figure 34. EIOM installation
Step 2.
Pull the EIOM slightly towards the rear side of the shuttle.
Step 3.
Connect required cables to the EIOM.
Step 4.
Turn the thumbscrews clockwise.
After you install the EIOM, complete the following steps:
1. Reinstall the shuttle (see
2. If the cable management arm is removed, install it (see
3. Reconnect the power cords and any cables that you removed.
4. Push all compute nodes back into the enclosure (see
5. Turn on all compute nodes.
6. Exit maintenance mode.
7. Check the following to verify whether the EOIM has been successfully replaced:
• The amber warning light on the node front panel is off.
• All the network ports on the EIOM are fully functional.
PCIe adapter replacement
Follow instructions in this section to replace PCIe adapters in the ThinkAgile VX3720.
Remove a PCIe adapter
Use this information to remove a PCIe adapter.
"Read the
installation
Guidelines" on
page 47
Before you remove a PCIe adapter:
68
ThinkAgile VX Enclosure ThinkAgile VX3720 User's Guide
Install the shuttle
).
"Power off
the compute
node
for this task"
on page 32
Install the cable management arm
Install a compute node in the chassis
Ground package before opening"
).
).
"ATTENTION:
Static Sensitive Device
on page 49
Advertisement
Table of Contents
