Raid Or Hba Adapter Replacement; Remove A Raid Or Hba Adapter - Lenovo ThinkAgile VX3720 7Y12 User Manual

Thinkagile vx7y12 series
Table of Contents

Advertisement

1. Reinstall the fan cover (see
2. Verify that the system fan is replaced successfully:
• The error LED for the replaced system fan is off.
• Amber warning LED on node front panel is off.
• No error is shown in the Lenovo XClarity Controller web interface.
• No error is shown in the Lenovo XClarity Administrator web console.
• No error is shown in the Lenovo XClarity Integrator console.

RAID or HBA adapter replacement

Use the following procedures to remove and install a RAID or HBA adapter.
A node may be able to self-correct for other adapter card errors, however, a failed HBA can lead to system
degradation and should be quickly addressed.
Note: The VX3720 contains the following HBA adapter.
Table 17. HBA options
Appliance
ThinkAgile VX3720
A failed HBA card is indicated by:
• vCenter Alarms or Hardware Status shows an alert.
• Slow disk performance or slow system performance.
• The hypervisor cannot detect SSDs and HDDs, or the red LEDs on the drives are illuminated.
• The hypervisor or BIOS does not detect the HBA card
Attention: Replacing a RAID adapter might impact your RAID configurations. Back up your data before you
begin to avoid any data loss due to a RAID configuration change.

Remove a RAID or HBA adapter

Use this information to remove a RAID or HBA adapter from the compute node.
"Read the
installation
Guidelines" on
page 47
Before you remove a RAID or HBA adapter from the compute node:
1. Place the node in maintenance mode by following the procedure
Storage and Availability Technical Documents Repository
2. Turn off the corresponding compute node that you are going to perform the task on.
3. Remove the compute node from the enclosure (see
4. Remove the compute node cover (see
62
ThinkAgile VX Enclosure ThinkAgile VX3720 User's Guide
).
Install the fan cover
"Power off
the compute
node
for this task"
on page 32
Remove the computer node cover
HBA option
1x 2U4N 430-8i 12GB SAS HBA
Ground package before opening"
Enter Maintenance Mode
.
Remove a compute node form the chassis
).
"ATTENTION:
Static Sensitive Device
on page 49
in the
VMware
).

Advertisement

Table of Contents
loading

Table of Contents