Table of Contents
Advertisement
Figure 47. M.2 drive installation
Attention: When sliding the retainer forward, make sure the two nubs on the retainer enter the
small holes on the M.2 backplane. Once they enter the holes, you will hear a soft "click" sound.
Figure 48. M.2 drive installation
After you install an M.2 drive in the M.2 backplane, complete the following steps:
1. Reinstall the M.2 backplane (see
2. Reinstall the compute node cover (see
3. Reinstall the compute node (see
4. Check the power LED to make sure it transitions between fast blink and slow blink to indicate the node
is ready to be powered on.
5. Power on the node.
6. Exit maintenance mode.
7. Use the Lenovo XClarity Provisioning Manager to configure the RAID. For more information, see:
http://sysmgt.lenovofiles.com/help/topic/LXPM/RAID_setup.html
8. Verify that the M.2 module is replaced successfully:
• The amber warning light on the node front panel is off.
Install the M.2 backplane
Install the compute node cover
Install a compute node in the chassis
).
).
).
.
Chapter 8
Hardware replacement procedures
81
Advertisement
Table of Contents
