System Management Module (Smm) - Lenovo ThinkAgile VX3720 7Y12 User Manual

Table 9. Components on x16 shuttle
1
10Gb 8-port EIOM cage (SFP+)
2
10Gb 8-port EIOM cage (RJ45)
3
10Gb 8-port EIOM cage filler
4
PCIe slot 3
5
PCIe slot 1
Note: Make sure the power cord is properly connected to every power supply unit installed.

System Management Module (SMM)

The following section includes information about the connectors and LEDs on the rear of the System
Management Module (SMM).
Figure 11. Rear view - SMM
Table 10. SMM
1
Reset pinhole
2
USB port service mode button
3
Ethernet connector
4
USB connector
You can access the dedicated XCC network port of the four nodes via the Ethernet connector on the SMM.
Go to SMM website and use IP to access XCC. For more details, see System Management Module User's
Guide.
The following four LEDs on the SMM provide information about SMM operating status.
5 System error LED (yellow):
When this LED is lit, it indicates that a system error has occurred. Check the event log for additional
information.
6 Identification LED (blue):
This LED could be lit to determine the physical location the specific enclosure in which the SMM is installed.
Use the following commands to control the identification LED and locate the enclosure.
• Turn on:
ipmitool.exe -I lanplus -H <SMM's IP> -U USERID -P PASSW0RD raw 0x32 0x97 0x01 0x01
18
ThinkAgile VX Enclosure ThinkAgile VX3720 User's Guide
6
Power supply 2
7
Power supply 1
8
System Management Module
9
PCIe slot 2
10
PCIe slot 4
5
System error LED (yellow)
6
Identification LED (blue)
7
Status LED (green)
8
System power LED (green)