Table of Contents
Advertisement
5. If the cable management arm is installed, remove it (see
6. Remove the shuttle (see
Complete the following steps to remove the EIOM.
• For 10GbE cage (SFP+) model
Figure 31. EIOM removal
• For 10GBASE-T cage (RJ-45) model
Figure 32. EIOM removal
Step 1.
Disconnect two cables from the EIOM.
Note: Make sure you push the release latch only when disconnecting the signal cable.
Step 2.
Turn the thumbscrews counterclockwise.
Step 3.
Grasp and push the EIOM slightly towards the front side of the shuttle.
Step 4.
Lift the EIOM up to remove the EIOM from the shuttle.
66
ThinkAgile VX Enclosure ThinkAgile VX3720 User's Guide
Remove the shuttle
) and place it on the stable work surface.
Remove the cable management arm
).
Advertisement
Table of Contents
