Call Processing; Enable; Minimum Digits; Country Code - Beam RST100 Configuration Manual

RST-100 INSTALLATION AND CONFIGURATION MANUAL

Call Processing

Enable

Turn on/off phone number processing on the RST. To turn on tick the Enable local
processing box, top left.
Allows local calls to be dialled just as if you were on a normal copper phone line. If disabled
most of the settings below have no effect except the voicemail shortcut. Even if enabled,
phone number processing can be turned off for a particular number by dialling # first.
Warning! Phone number processing only applies to RJ11 handsets.

Minimum Digits

The minimum number of digits entered to be interpreted as a valid phone number. Note this
is bypassed for information numbers. Default set to 8.

Country Code

This is the country code used for any local or national numbers dialled when the number is
sent to the network. Default is '61' for Australia. USA is '1'.
38