User Pins; Change Rst User Pin; Firmware Menu - Beam RST100 Configuration Manual

RST-100 INSTALLATION AND CONFIGURATION MANUAL

User PINS

The User PIN is set at factory default to 9876. the user PIN gives limited access to a user to
check the status of the terminal, send receive SMS messages and other basic functionality,
however it is not possible for the User to access the Supervisor menu functions or
configuration.

Change RST User PIN

Factory default as shipped is 9876. To change User PIN enter the New User PIN and then
re-enter it again, then press save.

Firmware Menu

From the BMS it is possible to update the version of firmware operating in the terminal if
required. This menu option allows you to simply update the firmware whilst connected to the
terminal. The update should only be performed under instruction from your Service Provider
or Beam Technical Support.
21