Settings Menu; Data / Sim Settings; Timeouts; Call Termination - Beam RST100 Configuration Manual

RST-100 INSTALLATION AND CONFIGURATION MANUAL

Settings Menu

Data / SIM Settings

Timeouts

Call Termination

The Call Termination parameter enables you to set how long to wait in minutes before
terminating a terminal initiated call if there has been no voice or data activity on the line for
the specified period of time. This field can be set to 0 to disable this feature and leave a call
up forever. The following parameters can fine-tune what 'nothing heard' means, allowing the
sensitivity and impulse immunity to be adjusted.

Data RX

Sets the wait Data RX

New feature only available on hardware Revision H.0 onwards.
This you to set enables how long to wait in seconds for characters on the Data port when in
AT command mode before reverting the RST to normal voice mode (so it can accept
incoming calls or make voice calls).
Once a Data call has connected this timer is ignored. '0' disables this feature and will stay in
AT command mode forever as long as DTR remains high.
27