Error Codes - Beam RST100 Configuration Manual

Error codes

The list of error codes are:
Error Code
1
2
3
4
5
6
7
8
9
RST-100 INSTALLATION AND CONFIGURATION MANUAL
Error Description
The non volatile memory on the RST was invalid on power-
up. Parameters are defaults.
Some sort of SMS system error. Usually unimportant. SMS
error code as PIN.
An equipment error reported from the LBT. ME error code as
PIN.
Over-temperature alarm from RJ11 line interface.
ROM checksum error on RST firmware. Continued correct
operation in doubt.
The RST has had to hardware reset the LBT due to a lack of
response. Can occur if LBT serial port locks up.
Short Burst Data sending error. MO error as PIN.
Short Burst Data reception error. MT error as PIN.
Battery Flat/Fault error.
19