Gefen EXT-UHDV-HBTLS-TX User Manual page 5

Operating Notes
Important
• While Unshielded (UTP) CAT-5e is usually adequate, shielded (STP) CAT-6A
is recommended. Shielded (STP) CAT-5e or unshielded (UTP) CAT-5e or CAT-
6A may be acceptable depending on cable quality. Care should always be given
to keep these cables away from power lines and other sources of electromagnetic
interference.
• Cable quality is critical when handling 4K HDMI signals. We highly
recommend Gefen HDMI cables. They have been designed and tested to reliably
transport the the full throughput of HDMI standard.
• Power Over HDBaseT (POH) is a standard HDBaseT™ implementation of PoE
that provides power from one device to the other over the link cable. This Sender
and Receiver units comply with the POH standard. The EXT-UHDV-HBTLS-TX
Sender can power the EXT-UHDA-HBTL-RX the Receiver, or the EXT-UHDA-HBTL-
RX Receiver unit can power the EXT-UHDV-HBTLS-TX Sender.
• The EXT-UHDV-HBTLS-TX and the EXT-UHDA-HBT-RX, wehen used together,
can pass both HDCP 2.2 and 1.4.
• The information in this manual has been carefully checked and is believed
to be accurate. However, Gefen and Core Brands, LLC assume no responsibility for
any inaccuracies that may be contained in this manual. In no event will Gefen and
Core Brands, LLC be liable for direct, indirect, special, incidental, or consequential
damages resulting from any defect or omission in this manual.
• All information contained herein is subject to change without notice.
5