NEC MultiSync PA271Q User Manual page 26

For security, you can set a password to access the HTTP server function. Please select "Enable" for HTTP Server Password
function. A-Z, 0-9, and some symbols can be used for the password. The default setting is [0000]. The user name is "PA271Q".
NOTE:
The default setting for the IP address is "Auto". When a LAN cable is connected, or after a monitor "Reset", the
IP address will be assigned automatically.
If the monitor appears to be slow in response to commands or clicks on buttons in the browser, or the general speed
of operation is unacceptable, this may be due to network traffic or the settings on your network. Should this happen,
consult your network administrator.
The monitor may not respond if the buttons shown on the browser are repeatedly pressed in rapid intervals. Should
this happen, wait a moment and repeat. If you still can't get a response, turn the monitor off and then back on.
The HTTP server function is confirmed on some major web browsers, however, it is not guaranteed to work with all
web browsers.
If the HTTP server screen does not appear in the web browser, refresh your web browser (or clear the cache).
Operation with a browser that uses a proxy server may not be possible depending on the type of proxy server and the
setting method. Although the type of proxy server will be a factor, it is possible that items that have been set will not
be shown depending on the effectiveness of the cache, and the contents set from the browser may not be reflected in
operation. It is recommended that a proxy server is not used unless the network environment requires it.
English-24