FIBARO Flood sensor Instruction Manual
Fibaro system
Hide thumbs
Also See for Flood sensor:
- Manual (72 pages) ,
- Quick start manual (14 pages) ,
- Quick manuals. warranty terms (48 pages)
Subscribe to Our Youtube Channel
Related Manuals for FIBARO Flood sensor
Summary of Contents for FIBARO Flood sensor
- Page 1 INSTRUCTION MANUAL FLOOD SENSOR FIBARO SYSTEM...
-
Page 2: Technical Support
Technical support Should you need any assistance in connecting or configuring your Home Center, please use our guides and technical presentations which can be found on our website: http://www.fibaro.com/en/support... -
Page 3: Functional Features
Functional features Flood sensor Temperature sensor Signal and Tilt sensor light alarm... - Page 4 Download FIBARO app for smartphone...
-
Page 5: Start The Device
Start the device STEP 1 Twist and open the casing. STEP 2 Take off the casing. - Page 6 Start the device STEP 3 Remove the battery blocker “I’m ready”. STEP 4 Check if the battery is placed correctly. You will hear a beep while LED diode blinks red.
- Page 7 Your Flood Sensor is ready to be added to the Home Center. Flood Sensor must be in range of the Home Center because it requires a direct communication with the controller.
- Page 8 Start inclusion mode STEP 5 Start your FIBARO application. Go to Settings.
- Page 9 Start inclusion mode STEP 6 Press “add device”. STEP 7 Press “Next”.
- Page 10 Inclusion mode has been launched...
- Page 11 Add your device STEP 8 Quickly, triple click the button in order to add your device to the system.
- Page 12 Processing your configurations...
- Page 13 Wake up the device Sometimes waking up the device is not required so it will be omitted automatically. STEP 9 Quickly, triple click the button in order to wake up the device.
- Page 14 The device has been added STEP 10 Name the device and assign it to the room.
- Page 15 Network range test It is recommended to check if the device’s destination is in range of your Home Center. STEP 11 Hold the button for about 10-15 seconds until LED diode blinks violet. STEP 12 Release the button, and press it again. The quality of the network range will be indicated by different colours of the LED diode.
- Page 16 Network range test – quality indicator Direct Routed Limited No signal! The device communication communication communication will not work correctly! STEP 13 Press the button in order to leave testing mode.
- Page 17 Close the casing STEP 14 Close and twist the cover.
-
Page 18: Installation
Installation During the installation it is recommended to wake up the device. 1. FIBARO Flood Sensor should be installed in all 3. A built-in temperature sensor lets you spaces, where’s the risk of flood: monitor e.g. floor’s temperature. • In the bathroom, •... - Page 19 If the sensor cannot fit the space which is in danger of flooding you can install a wired probe* that will get to difficult to access spaces. Here install the probe *The probe is not included in the Flood Sensor set.
- Page 20 www.fibaro.com...
Need help?
Do you have a question about the Flood sensor and is the answer not in the manual?
Questions and answers