Page 2
Feature Highlights Flood sensor Temperature sensor Signal and Tilt sensor light alarm...
Page 3
Start the device STEP 1 Twist open the casing. STEP 2 Take off the casing.
Page 4
Inclusion Process STEP 1 Tap Marketplace in bottom right corner...
Page 5
Inclusion Process STEP 2 Tap Connect New Device...
Page 6
Inclusion Process STEP 3 The app will say "I'm looking for Things...
Page 7
Start the device STEP 3 Remove the battery tab “I’m ready”. STEP 4 Check if the battery is placed correctly. You will hear a beep while LED diode blinks red.
Page 8
*Wake up the device *If the app does not automatically find the Flood Sensor then perform this step. (If automatically found then skip this step) STEP 5 Quickly, TRIPLE CLICK the button in order to wake up the device.
Page 9
Inclusion Success! STEP 6 Success, sensor was found, now tap below to configure.
Page 10
Completing inclusion STEP 7 Name the device and select which room it is in.
Page 11
Close the casing STEP 8 Close the sensor by twisting the cover closed.
Page 12
Installation 1. FIBARO Flood Sensor should be installed in 2. A built-in temperature sensor lets you locations where there's the risk of any water leaks: monitor for sudden change in temperature to prevent pipes freezing. • In the bathroom behind a toilet, •...
Page 13
To reach additional places like behind a washing machine or behind a refrigerator, you can install an additional probe.* Install wires here. Then knock out hole in bottom of sensor. *The probe is not included in the Flood Sensor set.
Need help?
Do you have a question about the FLOOD SENSOR and is the answer not in the manual?
Questions and answers