Operating Parameters - Pentair FLECK 2815 Service Manual

Water softener or filter control valve
Table of Contents

Advertisement

IMPORTANT PLEASE READ:
• The information, specifications and illustrations in this manual are
based on the latest information available at the time of release. The
manufacturer reserves the right to make changes at any time without
notice.
• This manual is intended as a guide for service of the valve only.
System installation requires information from a number of suppliers
not known at the time of manufacture. This product should be
installed by a plumbing professional.
• This product must be installed in compliance with all state and
municipal plumbing and electrical codes. Permits may be required at
the time of installation.
• Do not install the unit where ambient temperatures may
fall below 32°F (0°C) or rise above 120°F (52°C).
• Do not place the unit in direct sunlight. Black units will absorb radiant
heat increasing internal temperatures.
• Do not strike the valve or any of the components.
• Warranty of this product extends to manufacturing defects.
Misapplication of this product may result in failure to properly
condition water, damage to product, or personal injury.
• A prefilter should be used on installations in which free solids are
present.
• In some applications local municipalities treat water with
Chloramines. High Chloramine levels may damage valve components.
• Correct and constant voltage must be supplied to the controller to
maintain proper function.
• The system is intended to treat only potable quality water. It is not
intended as the permanent primary treatment of water from a source
that is contaminated, such as from radon, pesticides, insecticides,
sewage or wastewater.
• This system is not intended for use by persons (including children)
with reduced physical, sensory, or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
• Children shall not play with the system.
• Cleaning shall not be made by children without supervision.
• Periodic cleaning and maintenance may be required to function
properly.

OPERATING PARAMETERS

Minimum Pressure
Maximum Pressure
Minimum Water
Temperature
Maximum Water
Temperature
Maximum Humidity
FLECK
20 psi/1.38 bar/138 kPa
125 psi/8.62 bar/862 kPa
34°F/1°C
150°F/65°C
75%
2815 Control Valve Service Manual
• 3

Advertisement

Table of Contents
loading

Table of Contents