How To Use Panel Functions - 3M HCD-2 Operating Instructions Manual

How to use panel functions

10
seconds
2
seconds
5
seconds
10
seconds
08
Tank Heating / Instant Heating Mode
1. Press "HOT SELECTION" button for 10 seconds.
2. Press "HOT SELECTION" button to change modes
→ Instant Heating → OFF
•Tank heating
•Tank Heating : Red LED ; Instant Heating :
Constant Water Function
1. Press "COLD/AMBI." button for 2 seconds to take ambient or cold water
•A setting sound "Ding dong" occurs and the "COLD/AMBI." LED blinks.
2. After 2 seconds, the "COLD/AMBI." LED will blink
then Green (ambient water). Tap the "COLD/AMBI." button during the
respective color blinking period to choose the desired water temperature.
3. After selecting cold or ambient water, press "WATER DISPENSING"
button and the water will be dispensed continuously.
•A " Ding dong " sound will play once.
•If no water is dispensed within 10 seconds, this function will cease to exist
until the next time it is set up again.
•Hot water is not available for constant water function.
4. Press either "COLD/AMBI." or "WATER DISPENSING" to stop dispensing
water. Thereafter, cold water will be selected for future dispense unless
Step 1 and 2 is repeated again.
•A sound "Ding dong-Ding dong" will be played.
Turning On Cold Water Selection (If "COLD" LED is not lit)
1. Press "COLD/AMBI." for 5 seconds and "COLD" LED turns Blue.
Cold water is selected.
Turning Off Cold Water Selection (If "COLD" LED is lit)
2. Press "COLD/AMBI." for 5 seconds and "COLD" LED is now turned off.
"COLD/AMBI." LED lights up Green. Ambient water is selected.
Silent Mode
1. Press "COLD/AMBI." button for 10 seconds. "WATER FULL", "COLD",
"HOT", "HOT (STAND-BY)" LEDs will blink 5 times.
•A setting sound "Ding dong" will play once.
Non-Silent mode
2. Press "COLD/AMBI." button for 10 seconds. "WATER FULL", "COLD",
"HOT", "HOT (STAND-BY)" LEDs will blink 5 times.
•A setting sound "Ding dong" will play once.
Green LED
Blue (cold water) and