Page 2
This guide will take you through the steps to get started with your FlashBoss TTL Transceiver. For a complete user manual with detailed instructions on using all the features of the FlashBoss, go to vellogear.com/flashboss_manual, and download the user manual PDF.
INSTALLING THE BATTERIES The FlashBoss is powered by two AA batteries. 1. Press down and slide the battery compartment door in the direction of the arrow to open. 2. Insert the batteries following the illustration inside the battery compartment, and...
Page 7
POWERING ON THE FLASHBOSS To turn on the FlashBoss, See the Settings Menu section move the power switch in the user manual to adjust to the On position. the amount of time before standby mode is enabled. The FlashBoss switches to...
Page 8
MOUNTING THE FLASHBOSS ON A CAMERA When mounted to a camera’s 1. Loosen the locking wheel, and hot shoe, the FlashBoss can insert the FlashBoss into the be used as a transmitter. camera’s hot shoe. Make sure the FlashBoss 2. Make sure the FlashBoss is...
Page 9
MOUNTING THE FLASHBOSS TO A STAND The Mini Stand Mounting to a Light Stand 1. Loosen the locking wheel, and 1. Screw the 1/4-inch receiver then insert the mounting foot on the bottom of the mini into the mini stand’s cold- stand onto the light stand’s...
Page 10
MOUNTING A FLASH TO THE FLASHBOSS A flash can be mounted A flash and FlashBoss can also be onto the FlashBoss when the used for remote operation with FlashBoss is attached to the the FlashBoss in receiver mode. camera. In this configuration,...
Part 15 of the FCC Rules. FlashBoss operation, or to function properly with the Operation is subject to the for answers to questions FlashBoss’s operating modes. Refer following two conditions: and troubleshooting, to your flash’s manual for enabling access the user manual at TTL mode.
To obtain warranty coverage, contact the Vello Customer Service Department to obtain a return merchandise authorization (“RMA”) number, and return the defective product to Vello along with the RMA number and proof of purchase. Shipment of the defective product is at the purchaser’s own risk and expense.
Need help?
Do you have a question about the FLASHBOSS and is the answer not in the manual?
Questions and answers