Panasonic FP7 User Manual page 81

• Limited
A value corresponding to the FP7 operation mode is set regardless of the communication
state with adapters registered in the scan list.
RUN mode : RUN
PROG mode : IDLE
Note)
Only the normal operation is available when the version of the FP7 CPU unit is older than
Ver.4.10.
 Method of selecting RUN/IDLE bit operation of cyclic communication
Set "RUN/IDLE bit operation of cyclic communication" in the EtherNet/IP basic configuration
according to the use situation.
• Normal
Select for performing the EtherNet/IP communication with all adapters registered in the scan
list.
Note)
When communication cannot be performed with all adapter devices (except FP7) registered in
the scan list normally with this setting, there are cases where the adapter devices that is
communicating normally cannot operate normally as the RUN/IDLE bit is sent as IDLE.
• Limited
Select this setting for the use in situations where a part of devices in the scan list are activated
and the others are stopped such as a test operation.
* e.g. Communication cannot be performed because the power supply of an adapter is OFF.
Besides this setting, the similar operation can be performed by the following method.
(1) Register only the adapter devices that you want to activate in the scan list.
(2) Set the other adapter devices in the scan list to be disabled.
8.1 Types of Control Data
8-3