Inserting The Sensors - Ametek JOFRA ATC-125 A Reference Manual

3.1.3

Inserting the sensors

Before inserting the sensors and switching on the calibrator, please
note the following important warning:
Warning
 Never use heat transfer fluids such as silicone, oil,
paste, etc. in the dry-block calibrator.
These fluids may penetrate the calibrator and cause
damage or create poisonous fumes.
Insert the sensors as shown in fig. 2a.
Insertion tube
Fig. 2a
20
Sensor under test
23-03-2009
Reference sensor
(if available)
105446 06