Remote Control Operation; Changing The Receiver And Remote; Control Addresses - Dish Network 135331 User Manual

4. On the UHF Pro remote control that came with the kit, press
and hold the SAT mode button for three seconds until all
mode buttons light. Then, let go.
5. Use the NUMBER PAD buttons to enter the number you wrote in
step 3.
6. Press the POUND (#) button. If you entered the address
correctly, the SAT mode button will flash three times.
U
SING THE
After you have installed the converter and set up your UHF Pro remote
control, make sure that the remote can control your receiver in the
same room and also from other places where you want to use the
remote control. If the remote cannot control the receiver, see
Troubleshooting the Kit on page 42.
R
EMOTE
This section describes how to use the remote control that came with the
kit.
C
HANGING THE
A
DDRESSES
1. Open the
guide for instructions on how to open this screen without using the
remote control. The
one
Remote Address
and a
Secondary Remote Address
: On the DISH Player-DVR 522 and DISH 322, program the
Note
remote control on TV1 only.
2. Press and hold the SAT mode button about three seconds,
until all the mode buttons light up, and then let go of the
SAT button. The SAT mode button will blink.
3. Use the NUMBER PAD buttons to enter any number from 1 to 16.
The SAT mode button goes out after you enter each digit, and then
lights up again.
Write down the number you entered: __________
: If using more than one UHF Pro remote control in your
Note
house, make sure that the remote controls are set to different
addresses from each other.
4. Press the POUND (#) button. If you entered the address
correctly, the SAT mode button will flash three times.
10
R
EMOTE
C
ONTROL
R
ECEIVER AND
System Information
System Information
, or it may show a
C
ONTROL
O
PERATION
screen. Consult your receiver user's
.
R C
EMOTE
screen will show either
Primary Remote Address
ONTROL