Checking The Remote Control Address; Setting Up To Control Other Devices - Dish Network 135331 User Manual

5. Press the RECORD button.
6. Make sure the
address number you entered in step 3.
7. Close the
receivers, this is done by selecting
guide for more information.
C
HECKING THE
To check the remote control address setting:
1. Press and hold the SAT mode button for three seconds
until all mode buttons light. Then, let go.
2. Press the POUND (#) button twice while watching the
SAT mode button.
3. Count the number of times the SAT mode button flashes.
This number is the remote address. For example, if the
SAT mode button flashes 6 times, this indicates the
remote address is set to 6.
S U
ETTING
To use the remote to control other devices (such as a TV, VCR, DVD
player, tuner/amplifier, or a second DISH Network satellite receiver),
you must first program it to control these other devices. You can do this
by either following the instructions in Setting Up Using Device Code
Tables on page 12, or the Setting Up Using Device Codes Scan
procedure described on page 13.
C
OMBINATION
If you are programming the remote to control a combination device,
such as a TV/VCR or a TV/DVD, program the remote control in one
mode, and then repeat the procedure in the other mode. For example, to
program the remote to control a TV/VCR using code 748, follow the
instructions to program the remote to control the TV using code 748,
and then repeat the instructions for the VCR using the same code.
L M
IMITED ODE
You can program your remote control in Limited Mode to keep from
accidentally changing the channel on your TV or VCR. When you use
the remote to control your TV in Limited Mode, you will only be able
to use the POWER, MUTE, and VOLUME buttons to control your TV.
System Information
System Information
R
EMOTE
C
P TO ONTROL
D
EVICES
screen shows the
screen. On most
. See your receiver user's
Done
C
ONTROL
O D
THER
A
DDRESS
EVICES
11