andrews WHiC56 Owner's Manual page 33

[For System[Rcrc]]
Operation
4
1) Select "AM8:00" using
the buttons.
2) Press the
complete the "End"
time setting.
<Adding Additional Time Periods>
1) Select "Add" using
the buttons.
2) Press the
3) Select the time period following
the procedures in Steps 3 to 4.
<Resetting All Time Periods>
1) Select "Reset" using
the buttons.
2) Press the
(All settings are cleared.)
3) Adjust the time period following
the procedures in Steps 3 to 4.
5
Press the button to
complete the time settings.
To Cancel the Recirculation System Operation Timer
1) Carry out steps 1 to 2.
2) Select "Cancelled"
using the buttons .
3) Press the button.
Screen Display
1)
2)
button to
1)
2)
button.
1)
2)
button.
"Recirc timer" and "Recirc timer on" are altenately
displayed on the menu (approximately 10 seconds)
(Example of home screen when the power ON/OFF button is turned "ON")
1)
2)
The screen returns to the Recirc Menu.
Description
* Every time when you press the
button, the time changes by one hour.
[To keep the current "End" time]
Here
Press the button without
changing the "End" time,
and proceed to step 5.
* You can set multiple operation
time periods.
* The timer will not activate without
pressing the
* If the time is not set, the time setting
screen is displayed (
* Until the timer is deactivated, the
recirculation system will operate
daily at the set "Start" and "End"
Lit
times.
* If the button is "ON", the
screen returns to the home screen
in approximately 10 seconds.
* If the timer is deactivated during
a recirculation time period,
recirculation will continue
until it is stopped using the
procedure shown on p.29.
button.
p.19).
31