Setting The Recirculation System Operation Timer - andrews WHiC56 Owner's Manual

Setting the Recirculation System Operation Timer

Operation
This example describes setting the recirculation system to operate between 5:00 am - 8:00 am.
Check that the current time is properly set.
Preparation
1
1) Press the
cover, Select "Recirc menu" using
the buttons.
2) Press the
2
1) Select "Recirc timer"
using the
2)Press the
3
1) Select "AM5:00" using
the buttons.
2) Press the
to complete the
"Start" time setting.
30
Cover shown
in the open
position.
Screen Display
(Setting the time
1)
button inside the
2)
button.
1)
buttons.
(Example of a display)
2)
button.
1)
Here
2)
button
* With the recirculation operation timer set, hot water
will be automatically circulated in the hot water pipes.
Even with this function activated, it may take several
minutes for hot water to be completely circulated
through the plumbing system. Set the timer to
activate the recirculation system prior to the first use
of hot water to ensure hot water is instantly available.
* Multiple recirculation time periods can be set.
* Until the timer is deactivated ( p.31), the recirculation
system will operate daily at the set times.
* When the recirculation system is turned "OFF" by the timer, the
water heater will still remain "ON" and can be used normally.
p.17)
* You can set the timer regardless
if the
* The previous setting is displayed.
* Every time when you press the
button, the time changes by one hour.
[To keep the current "Start" time]
Press the
the "Start" time, and proceed to step 4.
[To add additional time periods to the current
setting, or to cancel the previous setting]
1) Press the
2) Press the
3) Follow the procedures "Adding
Additional Time Periods" or
"Resetting All Time Periods" (
Description
button is "ON" or "OFF".
button without changing
button without setting "Start" time.
button without setting "End" time.
p.31).