Automatic Water Heater "On" Or "Off" Operation - andrews WHiC56 Owner's Manual

Automatic Water Heater "ON" or "OFF" Operation

Set the time to turn "ON" or "OFF" the
Operation
This example describes setting the "ON time" and "OFF time" to 10:00 am and 8:00 pm, respectively.
1. Check that the current time is properly set.
Preparation
2. Check the
1
1) Press the
inside the cover,
Select "Set PROG"
using the
2) Press the
2
1) Set the ON time to
"AM10:00" using
the buttons.
2) Press the
to complete the setting.
3
1) Set the OFF time to
"PM8:00" using
the buttons.
2) Press the
to complete the setting.
20
Cover shown
in the open
position.
Screen Display
(Setting the time
button is set to "OFF"
1)
button
2)
buttons.
button.
1)
2)
button
1)
2)
button
* If you set the time to turn "ON" or "OFF" the
button, the button is automatically
turned "ON" or "OFF" at the set time every
day by just turning the
* It is also possible to set only "ON" or
"OFF" operation.
* For recirculation systems, circulation is
started or stopped according to the
button condition, "ON" or "OFF".
button automatically
p.21)
* You can set the time regardless if
the
* The previously set "Start time"
and "End time" are displayed.
* The time changes in 10-minute
increments with each press of the
button, and then in 1-hour increments if
the button is kept pressed down.
* If the previous setting is OK, press the
* If you do not want to set the "Start time",
select "- : --" (located between AM 11:50
and PM 0:00 settings).
* The time changes in 10-minute
increments with each press of the
button, and then in 1-hour increments if
the button is kept pressed down.
* If the previous setting is OK, press the
* If you do not want to set the "End time",
select "- : --" (located between AM 11:50
and PM 0:00 settings).
button "ON".
Description
button is "ON" or "OFF".
button without setting "Start time".
button without setting "End time".