andrews WHiC56 Owner's Manual page 16

Names and Functions of Controllers-2
Screen Display
* The screen display shown below is for illustration purposes only.
The actual display will vary depending on how the water heater is being used.
* After a button is pressed, the display will gradually become darker to prevent unnecessary power
consumption by the remote controller.
Flame Symbol
The flame symbol is displayed during
combustion when using hot water or
recirculation functions.
Display for Temperature Setting
During normal operation, the set
temperature is displayed.
Display for High Temperature
Displays when the set temperature
is 55°C or higher.
( p.19)
Temperature Setting
(Ex.: 40°C)
Clock Display
(Ex.: AM10:15)
Normally the clock display is not shown when
the power ON/OFF button is "OFF".
* This setting can be changed so that the clock is displayed
even when the power button is turned "OFF". (
Error Code
A number will flash if a
failure occurs. ( p.44 )
What is the home screen?
The home screen is displayed when the
Normally, the hot water temperature and the clock, etc.
are displayed.
14
Display for Recirculation Operation
* For systems that use recirculation operation, the symbol
is displayed when the power ON/OFF button is set to "ON".
* It is displayed during the recirculation operation. ( p.18)
p.24)
button is "ON".
Locked Display
The lock symbol is displayed
when the remote controller is
locked. ( p.22)
Recirculation Timer
The clock symbol is
displayed when the
recirculation timer is
activated. ( p.31)
<Home Screen Example>