Dmx Pcb - JEM AF-2 Service Manual

DMX PCB

1. DISCONNECT FROM MAINS SUPPLY.
2. Move to a flat position and remove BOTTOM COVER.
3. Remove the 4 screws that hold the MOUNTING PLATE to the chassis.
4. Move the MOUNTING PLATE to one side and gain access to the rear of the plate.
5. Remove the screws holding the DMX PCB to the MOUNTING PLATE. (THROUGH XLR
SOCKETS)
6. Disconnect the wiring looms. (OBSERVE POLARITY).
7. Remove the PCB.
14