Table of Contents
Advertisement
11. Undo and remove the 4 bolts and washers that hold the fan to the chassis. (OBSERVE ORDER
OF WASHERS)
BOLT
12. Withdraw the fan from the chassis pulling the LOOM and GROMMET through the hole at the
same time.
13. Remove the FAN from the chassis and place on your workbench.
Refitting Your New Fan:
1. Feed the wires through the hole in the chassis.
2. Secure the FAN using the 4 bolts and washers ensuring not to cross thread the inserts.
3. Reconnect the EARTH LOOM to the EARTH POINT.
4. Reconnect the BLACK, BROWN AND PURPLE WIRES to their relevant place in the terminal
block. (RECRIMP IF NECESSARY)
5. Replace the BOTTOM COVER ENSURING TO RECONNECT THE EARTH LOOM
6. APPLY POWER TO THE MACHINE AND TEST THE FAN OPERATION.
PURPLE
GROMMET
BLACK
BROWN
12
Advertisement
Table of Contents
