Kramer VM-2DT Quick Start Manual

VM-2DT Quick Start Guide
This guide helps you install and use your VM-2DT for the first time.
Go to
upgrades are available.
Scan for full manual
Step 1: Check what's in the box
VM-2DT 1:2 HDBT Distributor
4 Rubber feet
Step 2: Get to know your VM-2DT
# Feature
1 PROGRAM Mini USB Connector
2 EDID SETUP Button
3 ACTIVE INPUT LED
4 HDBT LINK LEDs
5 OUTPUTS CONNECTED LEDs
6 ON LED
7 INPUT HDBT Connector
8 HDBT OUT Connectors
9 SETUP 8-way DIP-switches
10 SETUP 4-way DIP-switch
11 5V DC
VM-2DT Quick Start (P/N: 2900-300363QS REV 2)
www.kramerav.com/downloads/VM-2DT
Function
Use to send RS-232 commands. Connect to a PC to perform firmware upgrades (via
K-Upload) and work with the EDID Designer. K-Upload and EDID Designer can be
downloaded from our Web site
Press to capture the input EDID, force RGB mode or select the default EDID
Lights green when an HDMI signal is embedded on the HDBaseT input
IN Lights green when a link is established with the HDBaseT transmitter
OUT Lights green when a link is established with the HDBaseT receiver (1 and 2)
Lights green when an acceptor (sink) is detected on the HDBaseT receiver connected
to the output (from 1 to 2)
Lights green when the unit receives power
Connects to an HDBaseT source, for example VS-44DT
Connect to an HDBaseT acceptor (from 1 to 2), for example TP-580R
Use to set the IR (DIP-switches 1 and 2) and RS-232 (DIP-switches 5 and 6) command
behavior
For future use
+5V DC connector for powering the unit
to download the latest user manual and check if firmware
1 Power supply (5V DC)
1 Quick start guide
at:www.kramerav.com/manual/EDID Designer
P/N:
2900- 300363QS
TOOL Mounting bracket kit
Rev:
2