General Technical And Performance Data; Electrical Data; Digital & Analog I/O - Invertek Drives eco OPTIDRIVE Advanced User's Manual

4. General Technical and Performance Data

4.1. Electrical Data

4.1.1. Mains Supply Details
Supply Voltage Range
Supply Frequency
Inrush Current
Power Up Cycles
Single Phase Operation
4.1.2. Motor Control
Output Frequency Range
Output Voltage Range
Speed Regulation
Effective Switching Frequency
Acceleration Time
Deceleration Time
4.1.3. Overload Capacity
Overload Capacity
4.2. Digital & Analog I/O
4.2.1. Digital Inputs Specification
Voltage Range
Response Time
4.2.2. Inhibit (Safe) Input
Voltage Range
Response Time
4.2.3. Analog Inputs Specification
Range
Resolution
Accuracy
Scaling & Offset
4.2.4. Analog Outputs Specification
Range
Resolution
Accuracy
4.2.5. Relay Outputs (1x N.O, 1x C.O)
Maximum Switching Voltage :
Maximum Switching Current :
Optidrive Eco Advanced User Guide Revision 1.00
230 Volt Units – 200 – 240 Volt +10% / -10%
400 Volt Units – 380 – 480 Volt +10% / -10%
600 Volt Units – 500 – 600 Volt +10% / -10%
48 – 62Hz
< rated input current
>120 x / hr, evenly spaced
This is only possible with the dedicated single phase input drives – supplying a three phase drive with
single phase is not possible in this product range
0 to 500Hz in 0.1 Hz steps
Max Output Frequency = Max Switching Frequency / 16.
0 to Supply Voltage
Open Loop < 1% motor rated speed
4 – 32kHz – Drive size dependant
Four independent acceleration ramps
0 – 600 seconds, 0.01s resolution (Frame 2 & 3)
0 – 6000 seconds, 0.1s resolution (Frame 4 & above)
Four individual deceleration ramps
0 – 600 seconds, 0.01s resolution (Frame 2 & 3)
0 – 6000 seconds, 0.1s resolution (Frame 4 & above)
110% of rated current for 60 seconds, repeat cycle every 10 minutes.
150% of rated current for 1 second, repeat cycle every 10 minutes
8 – 30 V dc, Internal or External supply, NPN (positive logic)
< 8ms
Inhibit input 18 – 30V dc
Inhibit input < 100us for shutdown
Current : 0-20mA, 4-20mA. 20mA max input current
Voltage: -10-10V (Analog Input 1 Only), 0-10V, 0-5V, 0/24V, 30V max input
Analog Input 1: 12-bit + sign, <16ms response time (bipolar)
Analog Input 2: 12-bit, <16ms response time (Uni-Polar)
better than 1% of full scale
Parameter adjustable
Current : 0..20mA, 4..20mA, 20mA max
Analog : 0..10V, 0 / 24V (digital), 20mA max
10-bit
better than 1% of full scale
250VAC, 30 VDC
5A at 30 Volt DC, 6A at 250 Volt AC