TITLE
PM42 Service Repair Manual
LSS Adjust Assembly Replacement
1. Remove the three torx screws securing the LSS adjust assembly. See Figure 3.
2. Lift the LSS adjust assembly and release the belt from the gap sensor assembly.
Figure 3 – Media Sensor Assembly
LSS Adjust Assembly Replacement
1. Remove the lower LSS assembly from the bottom media guide assembly.
2. Lift the LSS adjust assembly and release the belt from the gap sensor assembly.
3
Model
PM42
1
2
DOCUMENT NO.
L3-GLBL-RPR-3872
(Rev A)
PAGE
Page 25 of 48
L3-GLBL-RPR-3872 (Rev A)