Printhead Lift Assembly - Honeywell PM42 Service & Repair Manual

TITLE
PM42 Service Repair Manual

Printhead Lift Assembly

OPERATION:
This section cover the replacement of printhead lift mechanism assembly replacement. Replacing the assembly
require removing the print motor assembly first and possible driver gears to gain access to the torx screws securing
the printhead lift mechanism on the electronic side. The print unit components would also need to remove
Tools Required
Description
Torx T10
Parts Required
Item Part Number
1 50125897-001FRE
2 TBA
3 1-994058-010
Printhead Lift Mechanism Assembly Replacement
1. Remove the print mechanism stepper motor prior to removing the printhead lift mechanism assembly.
2. Remove the print unit components.
3. Remove the torx screw securing the headlift sensor reflector.
4. Remove the torx screw securing the headlift compression spring and slide the printhead lift mechanism assembly
away from the spine (main deck)
Model
PM42
Description
FRE, ASSY,TPH SUB ASSY ASM
FRE, TBA
Screw MRT 3X10 FBZ, T10 (6±0.3 kgf.cm)
1
Printhead Lift Sub Assembly
DOCUMENT NO.
L3-GLBL-RPR-3872
(Rev A)
3
PAGE
Page 21 of 48
2
L3-GLBL-RPR-3872 (Rev A)
.
Qty
1
1
1