Table of Contents
Advertisement
The WVC uses a standard 9-volt alkaline battery to
operate the valve and program the controller. Battery life
is affected by the number of valve actuations, along with
the distance the solenoids are from the controller. Under
normal service conditions the battery should provide at
least one full year of service.
Note:
The WVC has non-volatile memory that retains
all program information when the battery is
removed or in the event the battery is drained.
To Install the Battery
1. Unscrew the rear half of the WVC body to gain access
to the battery compartment.
2. Snap the battery into the battery holder.
Note:
The battery holder is designed so that the
battery can only be inserted in one direction.
3. Make sure no water is inside the battery compartment.
Make sure that the seals are in good condition.
Screw the WVC body halves together to seal the
compartment.
Installing the Battery
5
Advertisement
Table of Contents
