Installing.the.battery - Hunter WVC Owner's Manual And Installation Instructions

InsTallIng The baTTery ...........................................................................
The.WVC.uses.a.standard.9-volt.alkaline.battery.to.operate.
the.valve.and.program.the.controller..Battery.life.is.affected.
by.the.number.of.valve.actuations,.along.with.the.distance.
the.solenoids.are.from.the.controller..Under.normal.service.
conditions.the.battery.should.provide.at.least.one.full.year.
of.service.
NOTE: The WVC has non-volatile memory
that retains all program information when
the battery is removed or in the event the
battery is drained.
To install the battery:
1.. Unscrew.the.rear.half.of.the.WVC.body.to.gain.access.
to.the.battery.compartment.
2.. Snap.the.battery.into.the.battery.holder.
NOTE: The battery holder is designed so
that the battery can only be inserted in one
direction.
3.. Make.sure.no.water.is.inside.the.battery.compartment..
Make.sure.that.the.seals.are.in.good.condition..Screw.
the.WVC.body.halves.together.to.seal.the.compartment.