Connecting A Weather Sensor - Hunter WVC-100 Owner's Manual & Installation Instructions

Connecting a Weather Sensor

A Hunter Mini-Clik rain sensor or other micro-switch-
®
type weather sensor can be connected to the WVC. The
purpose of this sensor is to stop watering when weather
conditions dictate.
To Connect a Weather Sensor to the WVC
1. Cut the yellow wire loop attached to the WVC at
approximately the middle of the loop.
2. Remove approximately ½" (13 mm) of insulation from
each wire. Attach each wire to each of the wires of the
weather sensor.
3. Secure both wire connections with waterproof
connectors.
Connecting a Weather Sensor
Programming the Controller
The WVC is simple to program with its companion,
the WVP Wireless Valve Programmer. The easy-to-
understand push-button design of the WVP allows you to
step through the process of programming and activating
manual watering with the press of a button. Further
information on operating the WVP can be found in your
WVP Owner's Manual.
11